Friday December 1, 2023 Guerneville CA.
Dirt bike work
My spanner wrench came in the other day, so now I can adjust the shock pressure.
I had most of the stuff out of the way so I could get at the shock to adjust it.
I wasn’t sure where I should set the shock adjustment. In the end I decided to set it to it’s highest setting as it was just too much work to get into here. There’s the new spanner wrench that I used to do the job. It wasn’t too hard with the right tools.
Getting all the plastic parts back in was quite a challenge as there are a lot of bolts in weird places. It was quite the puzzle. Trail and error got it done.I had one bolt left over. I looked hard, but couldn’t find out where it was supposed to be. I guess I don’t need that one, but I’ll save it, just in case.
I measured the seat height and it was around 34 inches so adjusting the shock didn’t cause the bike’s seat to rise any, but hopefully made it a lot stiffer so the tire won’t bottom out and hit. It was hitting real hard before, tearing stuff up.
Test ride
It was starting to drizzle as I took off for the hills, but, so far, it was real light, hardly enough to get one wet.
I rode up to the hilltop and stopped for a bit. You can see the light drizzle off in the distance.
I was riding down this road and ran into these downed trees. I’d forgotten about them, more than once as this was the third time I ran into them while riding around.
I made it back down to the bottom of the hill and stopped to sit on a chair on this trail I’d been working on to contemplate life for a bit. This is a nice quiet place to sit.
I made it back home. The shock adjustment seems to mostly be doing the trick. It still rubs a bit once in awhile but it’s a just barely rub and not tearing stuff up, so I’ll try it this way for awhile and see if it’s acceptable, which I think it is.
I spent the rest of the day in the house studying my new operator’s manual for the new machine.
Nice day.
